REV 02 ·

v0.29: every pin printed

3d printingtreasure chestttrpg
Bare black treasure chest frame and lid frame on a workbench

Version 29 of the treasure chest is on the bench, in PETG this time, at the new medium size.

The big change is the pins. Earlier versions locked the joints with short lengths of 1.75 mm filament, which worked but felt like a cheat on a chest that’s supposed to be joined like furniture. Now every joint uses a printed rivet pin: all sixteen frame joints, the hinges, the lid, and the plates that hold the hasp and handles.

Printed hasp and staple on the front rail

Getting there took a few rounds. The first top frame came off the printer with tight rails and perfect frame pins, but the staple and handle plates just fell off. Their pins were loose. A couple of test pieces later the holes were right, and the hinges got tightened while I was at it.

The end of the frame with the lid closed and the hasp hanging open

Next up is reprinting those plates and then the medium lid.

One lesson is already waiting for v0.30. Round pins have to print lying down, which needs supports, or standing up, which puts the layer lines across the pin and makes it weak. A square or diamond pin prints flat with no supports and keeps its strength. That’s the next version’s problem.